Clean up the site, remove the machine on the debris;
2, unscrew the screws of the bearing block, join conducting oil for lubricants (Open AB two holes into A hole until the hole B oil outflow until hand drive dynamic coupling two holes until gas emitting re-tighten the bolts of the two holes);
3, check the motor steering with lubricating
oil pump direction of rotation;
4, hand move couplings pump should be flexible rotation.
The boot should use the transport of heat-conducting oil filled with lubricating oil pump, air to get rid of the
lube oil pump, gate valve on the outlet pipe should be closed.
6, the transport of heat-conducting oil before driving to uniformly heat the warm-up is the use of heat-conducting oil is transported continuously through the pump;
Preheat standards: the temperature of the lubricating oil pump shell shall not be less than the inlet oil temperature of 40 ° C, the warm-up rate of 50 ° C / warm-up should the feet of the pump side of the nut to loosen 0.3-0.5 mm, the warm-up is completed should be tightened.
7, in the warm-up process, should always observe the oil pump operation, if it is found to run the undesirable phenomena should immediately stop maintenance;
8, should be checked before starting the foundation and loose bolts, seal is normal.
